ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Air Bag Control Module|Removal and Installation|Page 6294 > < Air Bag Control Module|Removal and Installation|Page 6292
Page 3
background image

2. Install the RCM.

1

Install the bolt.

2

Reposition the carpet.

3. Connect the battery ground cable.
4. With the restraint system diagnostic tools installed at all deployable devices, prove out the supplemental restraint system (SRS).  See: Air Bag

Systems/Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure

5. Disconnect the battery ground cable and wait at least one minute.
6. Restore the vehicle to operating condition.

1

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.
 Refer to Air Bag(s) Arming and Disarming.

Reactivate the supplemental restraint system (SRS). Refer to Air Bag(s) Arming and Disarming.

2

WARNING:  The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use.
Failure to remove could result in injury and possible violation of vehicle safety standards.

With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS).  See: Air Bag Systems/Air Bag(s)
Arming and Disarming/Service and Repair/Prove Out Procedure

Air Bag Control Module|Removal and Installation|Page 6294 > < Air Bag Control Module|Removal and Installation|Page 6292