Removing and Installing Seat Belt on Mustang V8-46L SC VIN Y (2004)
4. Using the special tool, remove the D-ring bolt.
INSTALLATION
NOTE:
-
Make sure the retractor tongue faces inboard.
-
Make sure the safety belt is not twisted.
1. The shipping clip must remain attached prior to the installation of the retractor into the vehicle. The clip must be removed after the retractor is
installed.
2. Position the safety belt anchor. Using the special tool, install the safety belt bolt.
3. Install a new mastic seal around the safety belt retractor before installing the retractor in the vehicle.
4. Position the safety belt retractor. Using the special tool, install the bolt.
