Mustang V8-4.6L SC VIN Y (2004)
Wheels: Service and Repair
Wheel Leaks
Material
WARNING: Wheel repairs that use welding or peening are not approved. An inner tube is not an acceptable repair for leaking wheels or
tires.
If the air pressure in a tire mounted on an aluminum wheel is found to be low, perform this procedure before considering installation of a new wheel.
1. Remove the tire and wheel assembly, and inspect the wheel for structural damage. If none exists, go to Step 2. If the wheel is damaged, install a
new wheel.
2. With the tire mounted on the wheel, locate the air leak using a water bath or equivalent method, and mark the location. Check the complete wheel
for possible additional leaks. When leaks are marked, dismount the tire marking valve location on the tire for correct indexing.
3. On the tire side of the wheel, thoroughly clean the leaking area with an appropriate choke cleaner or use sandpaper of approximately 80-grit to
remove all contamination. Using the sandpaper, score the surface of the leaking area to improve adhesion of the sealer. If the valve stem is close to
the area, remove it.
4. Use a clean cloth to remove all cleaner or sanding dust.
5. NOTE: Do not use a torch containing oxyacetylene.
Heat the prepared area with a Heat Gun or a propane torch until aluminum wheel repair compound flows. Apply the hot melt material over the
prepared area using a liberal flow and wiping action. Repair is most effective when heat is applied to the brake side of the rim, and the sealer is
melted by heat in the metal.
6. Apply only enough heat to melt the sealer, then remove the heat source. After repairing the leak, allow the wheel to cool until it can be handled
safety.
7. CAUTION: Use caution when mounting the tire so as not to damage the sealer.
Index and assemble the tire and wheel. Inflate the tire to the recommended pressure as indicated on the tire pressure decal.
8. Repeat Step 2 to verify repair.
9. When the repair is completed, balance the assembly and install it on the vehicle.
