Mustang V8-4.6L SC VIN Y (2004)
Axle Shaft Assembly: Service and Repair
Axle Assembly
Axle Assembly
Removal and Installation
1. CAUTION: The vehicle must be on level ground and at curb height.
Mark the rear shock absorbers relative to their protective sleeve.
^
During installation, raise the suspension to this reference mark before tightening the suspension fasteners.
2. Raise and support the vehicle.
3. Remove the rear wheel and tire assemblies.
4. CAUTION: Index-mark the driveshaft flange and pinion flange to maintain initial balance during installation.
CAUTION: The driveshaft centering socket yoke fits tightly on the pinion flange pilot. Never hammer on the driveshaft or any of its components
to disconnect the yoke from the flange. Pry only in the area shown, with a suitable tool, to disconnect the yoke from the flange.
Disconnect and position the driveshaft out of the way.
