Mustang V8-4.6L SC VIN Y (2004)
12. Disconnect the lower suspension arm and bushings from the axle.
13. Remove the axle from the vehicle.
14. CAUTION: Align the index marks on the driveshaft centering socket yoke and the pinion flange.
CAUTION: Install the driveshaft with new bolts. If new bolts are not available, apply Threadlock and Sealer EOAZ-19554-AA or equivalent
meeting Ford specification WSK-M2G351-A5 to the threads of the original bolts.
CAUTION: The driveshaft centering socket yoke fits tightly on the pinion flange pilot. To make sure that the yoke seats squarely on the flange,
tighten the bolts evenly in a cross pattern as shown.
CAUTION: Raise the suspension to-the reference marks on the rear shock absorbers before tightening the suspension fasteners.
NOTE: Apply High Temperature Nickel Anti-Seize Lubricant F6AZ-9L494-AA meeting Ford specification ESE-M124A-A to the rear anti-lock
brake sensor body where it will make contact when installed.
To install, reverse the removal procedure.
^
Check and, if necessary, fill the axle with the specified lubricant to the specified level.
