Mustang V8-4.6L SOHC VIN X (2003)
2. Remove the right hand restraints control module (RCM) bracket retaining bolt.
1
Position the carpet back at the right hand side of the Instrument Panel (I/P) center support bracket.
2
Remove the RCM bracket retaining bolt.
3. Remove the RCM with bracket.
1
Position the carpet back at the left hand side of the I/P center support bracket.
2
Disengage the RCM electrical connector locking clip.
3
Disconnect the RCM electrical connector.
4
Remove the two retaining bolts.
5
Remove the RCM with bracket.
INSTALLATION
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS AND
NOTES AT THE BEGINNING OF THE REMOVAL PROCEDURE.
1. Connect the RCM.
1
Position the RCM.
2
Install the bolts.
3
Connect the RCM electrical connector.
4
Slide and engage the RCM electrical connector locking clip.
5
Reposition the carpet.
WARNING: THE TIGHTENING TORQUE OF THE AIR BAG RESTRAINTS CONTROL MODULE (RCM) RETAINING BOLTS IS
CRITICAL FOR CORRECT SYSTEM OPERATION.
