Mustang V8-4.6L SOHC VIN X (2003)
8. Using the special tool and a suitable press, remove the inner differential pinion bearing.
9. NOTE: Do not remove the pinion bearing cups from the differential housing unless the cups are damaged.
To remove the bearing cups, tap alternately (with a brass drift of suitable length) on opposite sides of the cup to prevent the cup from cocking in
the casting.
Installation
Using special tool 205-054
NOTE: This is the preferred method for installing the pinion bearing cups. If necessary, proceed to Using special tools 205-153, 205-054, and
205-DO55 in this procedure for an alternate method.
1. Position the special tools and the inner and outer pinion bearing cups in their respective bores.
1
After placing the inner and outer bearing cups in their bores, place the special tool on the inner bearing cup.
2
Place the special tool on the outer bearing cup.
3
Install the special tool.