Mustang V8-4.6L SOHC VIN X (2003)
2. Tighten the special tool to seat the pinion bearing cups in their bores.
3. CAUTION: Always install new differential pinion bearings when installing new pinion bearing cups.
NOTE: If the feeler gauge can fit between a cup and the bottom of its bore at any point around the cup, remove and reseat the cup.
Check that the cups have seated correctly in their bores.
Using special tools 205-153, -024, -231, and -D055
NOTE: This is an alternate method for installing the pinion bearing cups. Carry out this procedure if pinion bearing cup installation was not done in
the previous steps.
4. Using the special tools, drive the outer differential drive pinion bearing cup into the differential housing.
