Mustang V8-4.6L SOHC VIN X (2003)
6. CAUTION: Installation without the correct tools can result in early seal failure.
Place the inboard CV joint stub shaft pilot bearing housing seal onto the special tools.
7. CAUTION: If the inboard CV joint stub shaft pilot bearing housing seal becomes misaligned in the bore during installation, remove it and install
a new one.
Carefully align the inboard CV joint stub shaft pilot bearing housing seal in the housing bore and install the seal.
8. CAUTION: Use special tool 205-461 to avoid damaging the new inboard CV joint stub shaft pilot bearing housing seal when installing the
halfshaft.
Install the halfshaft.
^
If the knuckle and halfshaft were removed as an assembly, refer to Axle Housing. If the halfshaft was removed from the knuckle, refer to
halfshaft.
Pinion Seal
Pinion Seal
Special Tools
Special Tool(s)
Removal
1. Remove the pinion flange.
