Mustang V8-4.6L SOHC VIN X (2003)
3. NOTE: If components are not marked and installed correctly, driveline imbalance can occur.
Index-mark the positions of the driveshaft components.
4. Clamp the U-joint tool in a vise.
5. Remove all four of the snap rings.
6. Remove the driveshaft flange yoke.
1
Position the driveshaft flange yoke in the U-joint tool.
2
Press out a bearing cup.
3
Remove the driveshaft flange yoke.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the driveshaft flange yoke.
