Mustang V8-4.6L SOHC VIN X (2003)
Synchronizer Hub: All Technical Service Bulletins
M/T - TR36550 5spd Jumps Out of Gear/ Gear Clash
TSB 04-15-6
08/09/04
TR3650 MANUAL TRANSMISSION - JUMPS OUT OF
GEAR 2ND AND/OR 3RD - CLASH NOISE AND/OR
RASPY FEEL ON GEAR ENGAGEMENT
FORD:
2001-2003 Mustang
ISSUE
Some 2001-2003 Mustang vehicles, equipped with TR36505 speed manual transmission may exhibit a clash noise and/or a raspy (rough) feel on gear
engagement during 1-2 or 2-3 shifts. The transmission may also exhibit a jump-out from 2nd and/or 3rd gear. The condition may be more pronounced
when the transmission is colder than 40°F (5°C).
ACTION
To service, install a Synchro Kit. The kit includes 2nd main shaft gear, 1-2 synchronizer assembly, 3rd main shaft gear 3-4 synchronizer assembly the
1-2 and 3-4 shift fork and rail assemblies, blocking rings and an oil fill level sticker. Add new transmission fluid and fill to the revised lower level. Refer
to the following Service Procedure.
SERVICE PROCEDURE
NOTE
ALL COMPONENTS IN THE KIT ARE REVISED AND MUST BE REPLACED.
NOTE
BLOCKING RINGS MAY APPEAR DIFFERENT THAN THOSE BEING REMOVED FROM THE TRANSMISSION.
NOTE
REFER TO THE WORKSHOP MANUAL SECTION 308-03 TO AID IN THE FOLLOWING PROCEDURE.
1.
Remove the transmission from the vehicle.
2.
Disassemble the transmission.
3.
Install all of the revised components included in kit 3R3Z-7124-AC.
4.
Clean oil from area 26 mm (1") below the transmission fill plug (Figure 1) and install the oil fill sticker included in the kit.
NOTE
THIS TSB DOES NOT AUTHORIZE REPLACEMENT OF THE CLUTCH ASSEMBLY AND RELEASE BEARING FOR NORMAL WEAR. IF
SUFFICIENTLY WORN, THE CUSTOMER MAY WISH TO HAVE THEM REPLACED AT THEIR EXPENSE. SOME DISCOLORATION
AND LIGHT SCRATCHES ON THE FLYWHEEL OR PRESSURE PLATE ARE CONSIDERED NORMAL AND RESURFACING IS NOT