Mustang V8-4.6L VIN H (2005)
Brake Caliper: Service and Repair
Brake Caliper Support Bracket, Rear
Brake Caliper Support Bracket
Removal and Installation
1. Remove the rear axle shaft.
2. Remove the 3 bolts and the brake disc shield.
^
To install, tighten to 20 Nm (15 ft. lbs.).
3. NOTE: Make sure the anti moan bracket holes, the brake caliper support bracket, and the brake caliper anchor plate holes line up during
installation.
Remove the anti moan bracket.
^
To install, tighten to 35 Nm (26 ft. lbs.).
4. Remove the 4 brake caliper support bracket nuts, bolts and the bracket.
^
To install, tighten to 68 Nm (50 ft. lbs.).
5. To install, reverse the removal procedure.
