Mustang V8-5.4L SC (2008)
Door Sensor/Switch (For Alarm): Service and Repair
DOOR DISARM SWITCH
Removal And Installation
1. Remove the LH front door trim panel.
2. Position the watershield aside.
3. Disconnect the door disarm switch electrical connector.
4. Separate the door disarm switch wiring harness retainer from the post on the LH door latch.
5. Remove the E-clip.
6. Remove the lock cylinder actuator pawl.
7. Remove the door disarm switch.
8. To install, reverse the removal procedure.
-
The door disarm switch mark must be positioned towards the harness side of the switch prior to installation.
