Mustang V8-5.4L SC (2008)
Assembly
All seats
1. Attach the 4 lumbar hooks and install the lumbar assembly to the backrest frame.
-
If equipped, connect the power lumbar electrical connector.
2. Position the backrest recliner release with cable and install the 2 rivets.
-
If necessary, install a tie strap, holding the cable to the backrest frame.
3. Route the backrest recliner release cable as noted during disassembly and install the cable and casing to the outboard recliner.
Seats with a new side air bag module
4. NOTE: When installing a new side air bag module after deployment, install a new module, module bracket, module-to-bracket nuts,
U-nuts-to-backrest frame, module and bracket-to-backrest frame bolts.
Install the side air bag module bracket on the side air bag module and tighten the 2 nuts.
-
Tighten the nuts to 6 Nm (53 lb-in).
All seats
5. WARNING:
-
Before installing the seat side air bag module/deployment chute assembly:
-
Inspect the side air bag module and mounting surfaces for any damage or foreign material.
-
Remove any foreign material from the mounting surfaces of the deployment chute, the seat backrest frame mounting bracket and
the air bag module cavity in the seat backrest foam pad.
-
Install new parts if damaged.
Failure to follow these instructions may result in the seat side air bag deploying incorrectly, which increases the risk of serious
