Mustang V8-5.4L SC (2008)
Special Tool(s)
Removal and Installation
CAUTION: To prevent system failure, it is necessary to carry out the occupant classification sensor (OCS) system reset when a front passenger
seat cushion is disassembled, a new trim cover installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS
system reset command.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the front seat.
2. Remove the clip and recline handle.
Driver seat with manual height adjust
3. Remove the manual height adjust handle center cover.
4. Remove the 2 screws and manual height adjust handle.
All seats
5. Remove the screw at the rear of the cushion side shield. Pull out on the side of the cushion side shield, release the retaining clips and pin-type
retainer and remove the side shield.
6. NOTE: Note wire harness routing for installation.
Separate the side air bag module electrical connector and wire harness pin-type retainers from the manual seat track bracket.
7. Release all cushion trim cover-to-cushion frame retainers.
8. NOTE: Note wire harness routing for installation.
Disconnect the safety belt buckle switch and separate the pin-type retainers from the seat track.
9. NOTE: Note wire harness routing for installation.
Separate the main seat electrical connector from the manual seat track.
Driver seat
10. NOTE: Note wire harness routing for installation.
Disconnect the seat position sensor and separate the pin-type retainer.
All seats
11. Remove the 4 nuts and manual seat track.
-
Lift the cushion foam pad to access the manual seat track nuts.
-
To install, tighten to 36 Nm (27 lb-ft).
12. Remove the bolt and safety belt buckle.
-
To install, tighten to 42 Nm (31 lb-ft).
13. To install, reverse the removal procedure.
14. Install the seat.
