ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Body - Water Leak Onto Front Floor Area|Page 7129 > < Cowl Moulding / Trim|Service and Repair
Page 1
background image

Front Door Weatherstrip: Customer Interest
Body - Water Leak Onto Front Floor Area

TSB 08-26-7

01/05/09

WATER LEAK - FRONT FLOOR AREA

FORD:
2005-2009 Mustang

This article supersedes TSB 07-14-6 to update the model years, part list and service procedure.

ISSUE
Some 2005-2009 Mustang vehicles may exhibit a difficult to diagnose water leak in the front floor area. This may be caused by loose grommets and/or
sealer skips around the cowl area, loose A-pillar window weatherstrip retainer, misaligned body harness grommet through the firewall, misaligned body
harness grommet from the passenger door.

ACTION
Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

NOTE

DO NOT REMOVE THE DASH OR THE DASH INSULATOR AT ANY TIME DURING THIS PROCEDURE.

Water Leak Testing Procedure

1.

To pressurize the cabin open trunk and remove the floor carpet. Remove the plastic tail panel cover. Remove side carpet push pins and move the
carpet aside. Locate the body vents in the lower rear corners of the trunk (rear of wheel wells) and tape them off. Close the trunk. Place the blower
motor on high. Turn air recirculation to off mode. Close windows and doors. Open the hood and spray soapy water along body seams / grommets,
particularly around the A-pillar / fender and hood hinge area, and check for bubbles.

Body - Water Leak Onto Front Floor Area|Page 7129 > < Cowl Moulding / Trim|Service and Repair