Mustang V8-5.4L SC (2008)
CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose may occur.
Remove the 2 brake caliper guide pin bolts and position the brake caliper aside.
^
Support the caliper using mechanic's wire.
3. Remove the brake pads and discard the spring clips.
4. Measure the brake disc thickness.
^
Install a new brake disc if not within specification.
5. Inspect the brake caliper.
^
If leaks or damaged boots are found, install a new brake caliper.
6. Inspect the brake caliper anchor plate assembly.
^
Check the guide pins and boots for binding and damage.
^
Replace worn or damaged pins. Lubricate the pins with the specified grease.
^
Install a new brake caliper anchor plate if it is worn or damaged.
Installation
1. Using the special tool, compress the brake caliper piston into the brake caliper bore.
2. Position the notch in the caliper piston up and down to align with the alignment pin on the brake pad.
3. CAUTION: Do not allow grease, oil, brake fluid or other contaminants to contact the pad lining material, or damage to components may
occur. Do not install contaminated pads.
NOTE: Install all hardware supplied with the pad kit.
Install the 2 new spring clips and the brake pads.
4. Position the brake caliper on the anchor plate and install the 2 brake caliper guide pin bolts until snug.
^
Tighten the RH caliper guide pin bolts in the following sequence:
-
Tighten the top bolt to 33 Nm (24 lb-ft).
-
Tighten the bottom bolt to 33 Nm (24 lb-ft).
^
Tighten the LH caliper guide pin bolts in the following sequence:
-
Tighten the bottom bolt to 33 Nm (24 lb-ft).
-
Tighten the top bolt to 33 Nm (24 lb-ft).
5. Install the wheel and tire.
6. Apply brakes several times to verify correct brake operation.
