Mustang V8-5.4L SC (2008)
Disc Brake System - Exploded View (Part 2)
Removal and Installation
1. Remove the rear axle shaft.
2. Remove the 3 bolts and the brake disc shield.
^
To install, tighten to 20 Nm (15 lb-ft).
3. NOTE: Make sure the anti-moan bracket holes, the brake caliper support bracket and the brake caliper anchor plate holes line up during
installation.
Remove the anti-moan bracket.
^
To install, tighten to 35 Nm (26 lb-ft).
4. Remove the 4 brake caliper support bracket nuts, bolts and the bracket.
^
To install, tighten to 68 Nm (50 lb-ft).
5. To install, reverse the removal procedure.
