Mustang V8-5.4L SC (2008)
2. Disconnect the brake fluid sensor electrical connector.
3. If equipped with a manual transmission, remove the clutch hose clamp and disconnect the clutch hose from the brake fluid reservoir.
4. Disconnect the 2 brake tube fittings from the master cylinder.
^
To install, tighten to 17 Nm (13 lb-ft).
^
Cap the brake lines and plug the master cylinder ports.
5. Remove and discard the 2 nuts and remove the brake master cylinder.
^
To install, tighten the new nuts to 15 Nm (11 lb-ft).
6. To install, reverse the removal procedure.
^
Bleed the master cylinder.
^
If equipped with a manual transmission, bleed the clutch master cylinder.
