Mustang V8-5.4L SC (2008)
Remove the A/C compressor pulley.
1
Install the special tool.
2
Remove the A/C compressor pulley.
7. CAUTION: Do not use air tools. Damage to the A/C clutch field coil or A/C compressor may result.
Remove the A/C clutch field coil.
1
Install the special tool.
2
Install the special tool.
3
Remove the A/C clutch field coil.
Installation
NOTE: If installing a new A/C compressor, the A/C clutch components should be reused unless obvious signs of damage are found. If excessive
grooving is found, a new A/C clutch disc and hub and A/C compressor pulley must be installed together. Otherwise, each component can be installed
individually where needed.
1. Visually inspect the A/C clutch disc and hub, A/C compressor pulley and A/C clutch field coil for damage.
-
Inspect for physical damage, including cracked or melted components or discoloration due to excessive heat.
-
Inspect for excessive wear, including grooving in the A/C clutch disc and hub or A/C compressor pulley that is more than fingernail depth.
-
Inspect for roughness in the A/C compressor pulley bearing.
2. Clean the A/C clutch field coil and pulley mounting surfaces.
3. CAUTION: Do not use air tools. Damage to the A/C clutch field coil or A/C compressor may result.
Install the A/C clutch field coil.
1
Place the A/C clutch field coil on the A/C compressor with the A/C clutch field coil electrical connector correctly positioned.
2
Place the special tool on the A/C clutch field coil.
3
Place special tool 412-065 on special tool 412-078.
4
Use the special tool to install the A/C clutch field coil.
