Mustang V8-5.4L SC (2008)
Information Bus: Initial Inspection and Diagnostic Overview
Inspection and Verification
INSPECTION AND VERIFICATION
1. Verify the customer concern.
2. Visually inspect for obvious signs of electrical damage.
VISUAL INSPECTION CHART
Electrical
-
Bussed electrical center (BEC) fuse(s):
-
42 (15A) (no communication with PCM)
-
45 (10A) (no communication with PCM)
-
56 (20A) (no communication with audio control module [ACM], satellite digital audio receiver system [SDARS] module)
-
59 (30A) (no communication with SJB)
-
63 (30A) (no communication with SJB)
-
65 (30A) (no communication with ABS module)
-
67 (30A) (no communication with SJB)
-
Smart junction box (SJB) fuse(s):
-
6 (5A) (no communication with ACM)
-
8 (10A) (no communication with instrument cluster [IC], no power to scan tool)
-
16 (5A) (no communication with IC)
-
17 (10A) (no communication with restraints control module [RCM])
-
18 (10A) (no communication with ABS module)
-
19 (5A) (no communication with IC, PCM)
-
Data link connector (DLC)
-
Wiring harness
-
Wiring, terminals or connectors
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
4. NOTE: Make sure to use the latest scan tool software release.
If the cause is not visually evident, connect the scan tool to the DLC.
NOTE: The vehicle communication module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM.
If the scan tool does not communicate with the VCM:
-
Check the VCM connection to the vehicle.
-
Check the scan tool connection to the VCM.
-
GO to Pinpoint Test L, to diagnose no power to the scan tool. See: Pinpoint Tests/Test L: No Power To The Scan Tool
5. NOTE: During the network test, the scan tool will first attempt to communicate with the PCM, after establishing communication with the PCM,
the scan tool will then attempt to communicate with all other modules on the vehicle.
Carry out the network test.
-
If the network test passes, retrieve and record the continuous memory DTCs and proceed to Step 6.
-
If the network test fails, GO to Symptom Chart to identify the module not communicating. See: Symptom Related Diagnostic Procedures
6. If the DTCs retrieved are related to the concern, go to DTC Charts. For all other DTCs, refer to Body Control Systems (Multifunction Electronic
Control Module). See: Diagnostic Trouble Code Descriptions/Module Communications Network
7. If no DTCs related to the concern are retrieved, GO to Symptom Chart. See: Symptom Related Diagnostic Procedures
Principles of Operation
PRINCIPLES OF OPERATION
NOTE: The smart junction box (SJB) is also known as the generic electronic module (GEM).
Vehicle communication utilizes both International Standards Organization (ISO) 9141 and controller area network (CAN) communications. ISO 9141 is
for diagnostic use only, and CAN is a method for transferring data among distributed electronic modules via a serial data bus.
The vehicle is equipped with 3 module communication networks:
