Mustang V8-5.4L SC (2008)
Connect - Type III
1. NOTE: Apply clean engine oil to O-ring seals.
Install the quick connect coupling onto the tube until fully seated.
2. CAUTION: Make sure the retainer clip clicks into place when installing.
Depress the retainer clip until it is flush with the quick connect coupling housing.
3. NOTE: Make sure the retainer clip is fully seated and locked onto the tube by pulling on the quick connect coupling.
Rotate the primary locking tab on the retainer clip to the closed position.
Disconnect - Type IV
WARNING:
-
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result
in serious personal injury.
CAUTION:
-
When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube or damage to the tube or connector retaining clip can occur. Apply clean engine oil to
the end of the tube before inserting the tube into the connector.
