Mustang V8-5.4L SC (2008)
RH Ignition Components
Removal and Installation
LH ignition coil-on-plugs
1. Remove the air cleaner outlet pipe.
2. Remove the 2 bolts and the LH ignition coil-on-plug cover.
-
Inspect the gasket. Install a new gasket if necessary.
-
To install, tighten to 10 Nm (89 lb-in).
3. Disconnect the 4 LH ignition coil-on-plug electrical connectors.
4. Remove the 4 LH ignition coil-on-plugs, using a twisting motion while pulling up on the ignition coil-on-plug.
RH ignition coil-on-plugs
5. Detach the wire harness retainer from the stud bolt and position the harness aside.
6. Remove the bolt, stud bolt and the RH ignition coil-on-plug cover.
-
Inspect the gasket. Install a new gasket if necessary.
-
To install, tighten to 10 Nm (89 lb-in).
7. Disconnect the 4 RH ignition coil-on-plug electrical connectors.
8. Remove the 4 RH ignition coil-on-plugs, using a twisting motion while pulling up on the ignition coil-on-plug.
All ignition coil-on-plugs
9. NOTE: Verify that the ignition coil-on-plug spring is correctly located inside the ignition coil-on-plug boot and that there is no damage to the tip
of the boot.
