Mustang V8-5.4L SC (2008)
FOR REPROGRAMMING THE RESTRAINT CONTROL MODULE (RCM)
NOTES:
^
The procedure below must be performed using IDS (Integrated Diagnostic System).
^
The software developed for this recall will only allow reprogramming of the vehicles involved in this recall.
^
The presence of any RCM fault codes will prevent reprogramming of the RCM. Should the vehicle have any faults that prevent reprogramming of
the RCM, IDS screen notes will direct the technician to repair the fault before proceeding.
^
The diagnosis and repair of fault codes stored in the RCM are not covered by this recall.
RCM REPROGRAMMING PROCEDURE:
1.
Verify that IDS is updated to software version (R53.7) P16 or later.
2.
Connect IDS to the Data Link Connector (DLC) and follow all screen prompts.
3.
Select the toolbox icon.
4.
Select "Module Programming".
5.
Select "Module Reprogramming RCM" and follow all instructions.
6.
When reprogramming is complete, IDS will provide a 12 digit serial number that serves as verification that the latest calibration was properly
transferred.
