Mustang V8-5.4L SC (2008)
Removal
WARNING: Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the SRS.
2. Make sure the road wheels are in the straight-ahead position.
3. Tilt the steering wheel in the DOWNWARD position and LOCK the tilt handle.
4. Remove the driver air bag module.
5. Remove the LH A-pillar lower trim panel.
6. Remove the 2 screws and the steering column opening cover.
-
Disconnect the headlamp and courtesy light switches electrical connectors.
7. Remove the 3 lower steering column shroud screws.
8. Remove the upper steering column shroud.
9. Remove the lower steering column shroud.
10. Remove the steering wheel.
11. NOTE: If the clockspring is to be reinstalled, do not allow the clockspring to turn from its removal position.
