Mustang V8-5.4L SC (2008)
Seat With a Service Kit Occupant Classification Sensor (OCS)
Removal
WARNING: Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the kit
components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious personal
injury or death in a crash.
CAUTION:
-
There are 3 occupant classification sensor (OCS) system service kits available for this vehicle (base seat, heated seat and power heated
seat). Always make sure the correct OCS system service kit is installed.
-
To prevent system failure, it is necessary to carry out the occupant classification sensor (OCS) system reset when a front passenger seat
cushion is disassembled, a new trim cover installed or an OCS system service kit is installed. A scan tool is used to to carry out the OCS
system reset command.
NOTE:
-
The heated seat element on the front passenger seat cushion is not serviceable separately. If a new heated seat element is needed on the front
passenger seat cushion, a new occupant classification sensor (OCS) system service kit equipped with a heated seat element must be installed.
-
OCS system components (seat cushion foam pad, bladder with pressure sensor and occupant classification system module [OCSM]) are calibrated
to each other and are serviced as an assembly. The OCS system components are not to be installed separately. If a new OCS system, OCS system
component or seat cushion foam pad are needed, a new OCS system service kit (seat cushion foam pad, bladder with pressure sensor, electronic
control unit and seat wiring harness) must be installed as an assembly.
-
To identify between a production OCS system and a OCS system service kit inspect the OCSM electrical connector. A production OCS system
allows the disconnect of the OCSM electrical connector. A OCS system service kit has the OCSM electrical connector glued to the OCSM. It
