Mustang V8-5.4L SC (2008)
Wheel Bearing: Service and Repair
Front
Wheel Bearing and Wheel Hub
Wheel Bearing and Wheel Hub
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part number or equivalent part, if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
1. Remove the wheel and tire.
2. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the brake anchor plate bolts and position the brake caliper and anchor plate assembly aside.
^
Support the caliper and anchor plate assembly using mechanic's wire.
^
To install, tighten to 115 Nm (85 lb-ft).
3. Remove the brake disc.
4. Remove and discard the wheel hub grease cap.
