Mustang V8-5.4L SC VIN S (2007)
-
Tighten to 25 Nm (18 ft. lbs.).
21. Install the 2 power steering reservoir bracket bolts.
-
Tighten to 25 Nm (18 ft. lbs.).
22. Install the power steering tube bracket bolt.
-
Tighten to 10 Nm (89 inch lbs.).
23. Install the power steering tube bracket nut to the generator stud bolt.
-
Tighten to 10 Nm (89 inch lbs.).
24. Connect the A/C pressure transducer electrical connector.
25. Install the lower radiator hose assembly to the coolant pump, radiator, oil filter adapter and the coolant tube assembly (located above the
generator).
26. Connect the coolant hoses from the CAC.
27. Connect the 2 upper radiator hoses to the intake manifold.
28. Connect the 2 coolant vent hoses to the intake manifold.
29. Install the crankshaft front seal.
30. Install the thermostat housing.
31. Install the 3 supercharger (SC) drive belt idler pulleys, SC drive belt and the SC drive belt tensioner.
32. Install the coolant pump pulley and the 4 bolts.
33. Install the 2 accessory drive belt idler pulleys, the accessory drive belt tensioner and the accessory drive belt.
34. Tighten the 4 coolant pump pulley bolts to 25 Nm (18 ft. lbs.).
35. Install the RH and LH valve covers.
36. Install the SC coolant degas bottle.
37. Install the engine coolant degas bottle.
38. Install the strut tower cross brace and the 4 nuts.
-
Tighten to 35 Nm (26 ft. lbs.).
39. Fill and bleed the SC cooling system.
40. Fill and bleed the engine cooling system.
