Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
8.
The moulding can now be seated by pulling down on the lower flange of the rocker panel moulding. Refer to Figure 1. Pressure should be applied
to the top of the moulding while pulling down.
NOTE
YOU SHOULD BE ABLE TO HEAR A "CLICK" AS EACH OF THE CLIPS ARE SEATED.
9.
Align the moulding's lower holes with the holes provided in the vehicle and install the eight (8) push pins.
10.
Reinstall the screw into the rear of the rocker panel moulding.
