Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Rear Disc Brake Assembly Description
REMOVAL
1. Remove the three bolts that retain the rear wheel disc brake shield to the rear disc brake adapter.
2. Remove the rear wheel disc brake shield.
INSTALLATION
1. If the rear wheel disc brake shield is bent, straighten it before installation.
NOTE: RH and LH rear wheel disc brake shields are interchangeable.
2. Position the rear wheel disc brake shield to the rear disc brake adapter.
3. Install mounting bolts and tighten to 8-12 Nm (70-106 inch lbs.).
4. Check that the tabs on the rear wheel disc brake shield should not interfere with the rear wheel disc brake adapter and rear wheel disc brake shield
mounting flange.