Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Cruise Control Servo Cable: Service and Repair
REMOVAL
1. Remove screw attaching speed control actuator cable to accelerator cable bracket.
2. Disconnect speed control actuator cable from throttle lever arm by pulling up and off of nailhead.
3. Remove speed control servo.
4. Slide speed control actuator cable from engine compartment through fender apron hole and remove speed control cable from vehicle.
INSTALLATION
1. Install speed control servo (do not install front fender splash shield).
2. Reroute speed control cable through hole in fender apron and over power brake booster.
3. Place speed control cable on accelerator cable bracket and install screw. Tighten to 9.1-11.9 N.m (81-105 lb-in).
4. Snap speed control fitting onto throttle lever arm.
5. Check speed control cable adjustment.
NOTE: Incorrect wrapping of speed control cable core wire around speed control servo pulley may result in high idle condition. Make sure that
throttle lever is at idle position after cable installation and adjustment.
6. Install front fender splash shield.
