Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
8. Carefully pry away RH side of steering wheel back cover to allow enough clearance to remove RH side speed control switch wiring from steering
wheel. Repeat on the LH side and remove speed control actuator switch.
INSTALLATION
1. Carefully pry away RH side of the steering wheel back cover to allow enough clearance to insert RH side of the speed control switch wiring into
steering wheel. Repeat on LH side.
2. Position speed control actuator switch onto steering wheel and install four Phillips-head screws.
3. Connect all harness connectors and route wiring in steering wheel cavity. Install wire organizer.
CAUTION: Make sure wires are positioned so that no interference is encountered when installing air bag module.
4. Position driver side air bag module on steering wheel and connect air bag sliding contact.
5. Install driver side air bag module on steering wheel and install two screw and washer assemblies. Tighten to 10.2-13.8 N.m (91-122 lb-in).
6. Install two back cover plugs.
7. Re-connect positive battery cable.
8. Re-connect battery ground cable.
9. Check operation of speed control actuator switch.
10. Prove out air bag system.
