Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Fig. 17 Setting Engine To TDC Of No. 1 Cylinder
1. If cylinder head was removed from cylinder block, position crankshaft keyway to 270° (or at nine o'clock position).
NOTE: The rocker arms must not be installed in the cylinder heads at this time.
2. Install cylinder heads on cylinder block.
LH Camshafts Keyways
3. Install Camshaft Positioning Tool T93P-6256-A into D-slots on rear of camshafts to position both intake and exhaust camshafts with the keyways
pointing down toward crankshaft.
NOTE: Do not remove Camshaft Holding Tool T93P-6256-AH from camshafts until all parts are installed and tightened.
4. Install Camshaft Holding Tool T93P-6256-AH on center of camshafts.