Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
5. Rotate dial to menu item "Retrieve/Clear Continuous DTC", press trigger, then press start (Button 3).
6. To clear an individual DTC from selected module, highlight DTC by rotating dial then press Button 8.
7. To clear all DTCs from selected module, press Button 7.
Retrieve PID Information
NOTE: This test is used to verify operation of input circuitry to the module being tested.
Retrieve PID Information
1. Perform Hookup and Vehicle Selection as described.
NOTE: The ignition switch must be in RUN or test will fail.
2. Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. Select module by rotating dial to highlight module and press trigger.
4. Rotate dial to highlight menu item "PID/Data Monitor and Record," press trigger.
5. Select PID acronyms by rotating dial to highlight a PID and then press trigger. Repeat this process until all PIDs are selected. (* - indicates that a
PID has been selected.)
6. Press Button 7 to view all selected PIDs. Diagnostic Commands.
Diagnostic Commands
NOTE: This test is used to verify the operation of the output circuitry of the module being tested
Diagnostic Commands
1. Perform Hookup and Vehicle Selection.
NOTE: The ignition switch must be in RUN or test will fail.
2. Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. Select module by rotating dial to highlight module and press trigger.
4. Rotate dial to highlight menu item "Active/Command Modes," press trigger.
5. Rotate dial to selected command and press trigger. Command the output by rotating dial and pressing trigger as needed.
Retrieve Module Identification
NOTE: This test is used to verify the correct version level of the module being tested.
Retrieve Module Identification
1. Perform Hookup and Vehicle Selection.
NOTE: The ignition switch must be in RUN position or test will fail. Review the New Generation Star (NGS) Tester Manual for more details.
2. Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. Select module by rotating dial to highlight module and press trigger.
4. Rotate dial to highlight menu item "Module Identification," and press trigger.
Vehicle Set Up
New Generation Star Tester Driven Diagnostics Vehicle Set Up
1. Perform the following steps prior to performing any New Generation Star Driven Diagnostics:
a. Shift transmission to PARK.
b. Apply parking brake.
c. Make sure all switches and controls are in the OFF position.
d. Hook up New Generation Star (NGS) Tester.
e. Close all doors, hood and luggage compartment door.
f.
Turn ignition switch to RUN
NOTE: Do not operate any handle, control or switch that may produce a module input unless instructed to do so by New Generation Star program.
2. Perform Vehicle Selection.
3. Perform Data Link Diagnostics Test.
