Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Engine Coolant Temperature (ECT) Sensor
REMOVAL AND INSTALLATION
1. Partially drain engine cooling system.
2. Disconnect battery ground cable.
NOTE: When the battery has been disconnected or reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module
(PCM) relearns its fuel trim. The vehicle may need to be driven 16 km (10 miles) or more to relearn the fuel trim.
3. Disconnect fuel charging wiring from Engine Coolant Temperature (ECT) sensor.
4. Remove ECT sensor from water bypass tube.
5. To install, reverse Removal procedure. Tighten ECT sensor to 8-12 Nm (71-106 lb in).
6. Refill engine cooling system.
