Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Side Air Bag: Service and Repair
Driver Side Air Bag Module
NOTE: If the driver side air bag did not deploy in a collision, it may not have been needed. Complete all diagnosis before replacing the driver side air
bag module.
REMOVAL
1. Record USER 1 and USER 2 preset radio frequencies for reprogramming following completion of service procedures.
2. Disconnect battery ground cable. Wait one minute for backup power supply to deplete its stored energy.
WARNING: The electrical circuit necessary for system deployment is powered directly from the battery. To avoid accidental deployment
and possible personal injury, the battery ground cable must be disconnected prior to servicing or replacing any system components.
3. Remove two back cover plugs. Remove two screw and washer assemblies retaining driver side air bag module to steering wheel.
4. Disconnect the air bag sliding contact connector from driver air bag wiring. Remove driver side air bag module.
WARNING: Place driver side air bag module on bench with trim cover facing up to avoid accidental deployment and possible personal
injury.
INSTALLATION
1. Connect driver air bag wiring to air bag sliding contact connector.
NOTE: Fill out and return air bag traceability postcard for new air bag with VIN numbers. Note diagnostic trouble codes.
2. Position driver side air bag module to steering wheel and secure with two screw and washer assemblies. Tighten to 10.2-13.8 Nm (91-122 lb in).
3. Reconnect battery ground cable.
4. Prove out air bag system.
5. Reprogram USER 1 and USER 2 radio frequencies and set clock.
