Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Air Bag Control Module: Service and Repair
REMOVAL
1. Record pre-set radio frequencies for reprogramming following completion of service procedures.
2. Disconnect battery ground cable. Wait one minute for backup power supply to deplete its stored energy.
WARNING: The electrical circuit necessary for system deployment is powered directly from the battery. To avoid accidental deployment
and possible personal injury, the battery ground cable must be disconnected prior to servicing or replacing any system components.
3. Disconnect air bag diagnostic monitor electrical wiring connectors.
NOTE: Air bag diagnostic monitor is the blue box with two connectors mounted below the climate control assembly.
4. Remove screws retaining air bag diagnostic monitor and bracket to instrument panel brace and remove air bag diagnostic monitor and bracket.
INSTALLATION
1. Position air bag diagnostic monitor and bracket on instrument panel and install retaining screws. Tighten to 10.2-13.8 Nm (91-122 lb in).
2. Connect electrical wiring connectors to air bag diagnostic monitor.
3. Reconnect battery ground cable.
4. Prove out air bag system.
5. Reprogram USER 1 and USER 2 radio frequencies and set clock.
