Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Case: Service and Repair
Service Procedures
NOTE: The following procedure should be performed only when necessary. After carefully inspecting each subassembly, disassemble only those
requiring component replacement or further inspection.
DISASSEMBLY
1. Install Seal Remover TOOL-1175-AC or equivalent on output shaft rear support bearing cup as shown.
2. From rear of case, place Driver Handle T80T-4000-W in the center of Seal Remover. Using press, remove rear support bearing cup.
3. Place Seal Remover on countershaft middle bearing cup in case as shown.
