Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Synchronizer Hub: Service and Repair
NOTE: The following procedure should be performed only when necessary. After carefully inspecting each subassembly, disassemble only those
requiring component replacement or further inspection.
DISASSEMBLY
1. Before disassembling the synchronizer, scribe alignment marks on the sleeve and hub for assembly reference.
NOTE: The following procedures apply to all synchronizer assemblies.
2. Using a small screwdriver, remove the two synchronizer strut springs.
3. Remove the three synchronizer hub struts. Slide sleeve off hub.
ASSEMBLY
Assemble the synchronizer hub struts and strut springs onto the synchronizer sleeve and hub. The strut springs engage the same hub strut but rotate
in opposite directions.
NOTE: When assembling a synchronizer sleeve and hub, match the alignment marks made during disassembly. The sleeve and hub have an
extremely close fit and must be held square during assembly to prevent jamming. Do not force the sleeve onto the hub.
