Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Windshield Washer Switch: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Place a 3.17 mm (1/8-inch) diameter wire pin or small drift punch in hole in steering column shroud under ignition switch lock cylinder. Depress
retaining pin while pulling out on ignition switch lock cylinder to remove it from steering column tube housing.
3. Remove four screws retaining steering column shrouds and remove steering column shrouds.
4. Disconnect electrical connectors from multi-function switch.
5. Remove two screws retaining multi-function switch to steering column and remove multi-function switch.
INSTALLATION
1. To install, reverse removal procedure. Tighten two multifunction switch screws to 2.1-2.9 N.m (19-25 Lb-In). Tighten four steering column
shroud retaining screws to 0.6-1.0 N.m (6-8 Lb-In).
