Mustang Cobra V8-4.6L DOHC VIN V (2000)
3. If there is interference between the hood latch and striker, loosen the three (3) fasteners in the hood latch support bracket that attaches it to the
radiator support (one on the top side and two on the forward side) (Figure 2).
4. Move the hood latch support bracket approximately 2mm in the opposite direction of the interference and tighten the top fastener.
5. Perform Step 2 to see if the interference condition has been eliminated; if not, repeat Step 4 until the hood latch freely engages the striker.
6. Secure all three (3) fasteners holding the hood latch support bracket to the radiator support to 12 Nm (9 lb-ft) (Figure 2).
7. Place a pair of channel lock pliers on the front side of the hood latch support bracket and force upward until the bracket is bent approximately 4
degrees (bend bottom of bracket forward). Do this by bending the bracket on both sides of the latch.
8. Check the hood closing effort by raising the hood 25 cm (10") and close to ensure that c6ndition has been eliminated. If a hood closing effort still
exists, repeat Step 7 until it has been eliminated.
9. Secure the fastener that attaches the pencil bracket to the bottom of the radiator support to 12 Nm (9 lb-ft) (Figure 1).
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION, DESCRIPTION
DEALER CODING
OASIS CODES: 111000,112000