Mustang Cobra V8-4.6L DOHC VIN V (2000)
9. For front wheels, measure and record the total indicated runout of the hub face outside the stud circle.
10. Install a new front hub if the total indicated runout exceeds the maximum specification.
^
Repeat the hub runout measurement.
11. Note: Clean the axle flange surface before measuring.
Note: For rear wheels, press inward on the axle shaft while measuring the rear axle runout.
For rear wheels, measure and record the total indicated runout at a point on the axle shaft outside the stud circle.
12. If the total indicated runout exceeds the maximum specification, inspect the rear axle. Repair as necessary.
^
Repeat the rear brake disc runout measurement.
13. If the brake disc TIR is still out of specification, measure and record the thickness of the brake disc. If thickness is sufficient to machine the brake
disc to the runout specification, go to Step 14. If the thickness is not sufficient, install a new brake disc and recheck the TIR.
14. Note: Brake disc machining must be done with an on-vehicle lathe. Follow the lathe manufacturer's instructions.
Machine the brake disc if final thickness will not be less than the maximum specification. Recheck the brake disc runout.
