Mustang Cobra V8-4.6L DOHC VIN V (2000)
Evaporative Check Valve: Service and Repair
REMOVAL
1. Remove the fuel tank. For additional information, refer to Fuel Delivery and Air Induction.
2. Remove the retainers.
3. Remove the fuel vapor control valve tube assembly.
1
Loosen the fuel vapor vent valve.
2
Loosen the fuel vapor control valve.
3
Remove the fuel vapor control valve tube assembly.
NOTE:
^
The fuel vapor vent valve, fuel vapor control valve and the in-line fuel tank pressure sensor are repaired as a fuel vapor control valve tube
assembly.
^
It may be necessary to lubricate the fuel vapor control valve tube assembly grommets with ESE-M00B144-B Merpol(R) or equivalent to assist
in the removal procedure.
INSTALLATION
1. To install, reverse the removal procedure.
^
Leak test the system. For additional information, refer to Evaporative Emission System Leak Test. See: Testing and Inspection/Component
Tests and General Diagnostics/Evaporative Emission System Leak Test
^
Carry out the evaporative emission repair verification drive cycle. For additional information, refer to Evaporative Emission Repair
Verification Drive Cycle. See: Service and Repair
NOTE:
^
Lubricate all O-ring seals with MERPOL(R) O-Ring Seal Lubricant or equivalent meeting Ford specification ESE-M99B144-B.
^
New grommets are necessary when the fuel vapor control valve tube assembly is removed.
