Mustang Cobra V8-4.6L DOHC VIN V (2000)
Evaporative System Service Port: Service and Repair
REMOVAL
1. Disconnect the pin-type retainer.
2. Raise and support the vehicle. For additional information, refer to Maintenance/Service and Repair.
3. Remove the RH front wheel. For additional information, refer to Wheels, Tires, and Alignment.
4. Remove the RH front splash shield.
1
Remove the three screws.
2
Remove the five pin-type retainers.
5. Remove the evaporative emission test port by disconnecting at the EVAP canister purge outlet tube junction.
INSTALLATION
1. To install, reverse the removal procedure.
^
Leak test the system. For additional information, refer to Evaporative Emission System Leak Test. See: Testing and Inspection/Component
Tests and General Diagnostics/Evaporative Emission System Leak Test
^
Carry out the evaporative emission repair verification drive cycle. For additional information, refer to Evaporative Emission Repair
Verification Drive Cycle. See: Service and Repair
