Mustang Cobra V8-4.6L DOHC VIN V (2000)
12.
Install the front safety belt lower anchor bolt. Tighten the anchor bolt to 40 Nm (30 lb-ft).
13.
Install the rear backrest cushion. Tighten the retaining bolts to 11 Nm (8 lb-ft).
14.
Install the scuff plate.
15.
Install the rear seat cushion. Do not install if the rear seat safety belt retractors require replacement.
16.
Position both front seats to their original position.
REAR SEAT SAFETY BELT RETRACTORS
1.
Remove the rear seat cushion, if necessary.
2.
Remove the rear seat safety belt lower anchor bolt(s). See Figure 14.
3.
Open the trunk.
4.
Remove the front lining board (fabric panel covering underside of decklid).