Mustang Cobra V8-4.6L DOHC VIN V (2000)
15. Using the special tool, press the axle shaft from the hub (1109).
16. Remove the knuckle from the lower arm and bushing.
1. Remove and discard the nut and bolt.
2. Remove the knuckle.
17. Remove the dust shield, hub, snap ring and bearing from the knuckle.
Installation
1. Install the bearing, snap ring, hub and dust shield.
2. Install the knuckle.
1. Position the knuckle on the lower suspension arm and bushing.
2. Install a new bolt and a new nut. Do not tighten the nut at this time.
3. Connect the axle shaft to the hub.
1. Making sure the splines on the shaft line up with the splines in the hub, install the axle shaft into the hub.
