Mustang Cobra V8-4.6L DOHC VIN V (2000)
Pinion Flange: Service and Repair
Special Tools
Removal
1. Raise and support the vehicle.
2. Remove the rear wheel and tire assemblies.
3. CAUTION:
^
Remove the rear brake calipers to prevent drag during the drive pinion bearing preload adjustment.
^
Do not allow the calipers to hang from the brake hoses.
Remove the rear brake caliper and support bracket from the knuckle as an assembly. Wire the caliper and support bracket assembly out of the way.
4. CAUTION: Index-mark the driveshaft flange and rear axle pinion flange to maintain initial balance during installation.
Disconnect and position the driveshaft out of the way.
