Mustang Cobra V8-4.6L DOHC VIN V (2000)
1.
Raise vehicle on hoist. Using the appropriate year Mustang Workshop Manual, Section 205-01, replace the driveshaft. Refer to parts table for
application listing. Make sure that the front driveshaft yellow paint dot is aligned with the paint dot at the end of the transmission output shaft (A/T
only). Align the rear driveshaft yellow dot with the corresponding dot on the pinion flange (refer to Figure 1).
NOTE
FAILURE TO PROPERLY INDEX THE DRIVESHAFT MAY RESULT IN A DRIVELINE VIBRATION.
UPPER CONTROL ARMS
1.
Remove the two (2) rear upper control arms from the vehicle.
2.
Install the two (2) revised Upper Control Arms (1R3Z-5500-AA).
Refer to Workshop Manual Section 204-02 for removal and installation procedures.
NOTE
DO NOT TIGHTEN THE REAR LOWER CONTROL ARM BOLTS AT THIS TIME.
NEUTRALIZING CONTROL ARM BUSHINGS
