Mustang Cobra V8-4.6L DOHC VIN V (2000)
Slip Yoke: Service and Repair
Special Tools
Disassembly
1. Remove the driveshaft.
2. CAUTION: Under no circumstances is the driveshaft assembly to be clamped in the jaws of a vise or similar holding fixture. Denting or
localizing fracture can result, causing driveshaft failure during vehicle operation.
Place the driveshaft on a suitable workbench. Be careful not to damage the tube.
3. Note: If components are not marked and therefore installed incorrectly, driveline imbalance can occur.
Index-mark the driveshaft components.
4. Clamp the special tool in a vise.
5. Remove all four of the snap rings.
6. Note: If necessary, use a pair of pliers to remove a bearing cup if it cannot be pressed out all the way.
