Mustang GT V8-4.6L SOHC VIN X (1998)
1. With the RH front door open, position the radio antenna base and cable as an assembly in the front fender opening. Place the gasket in position
and install the antenna base to the front fender with three retaining screws. Tighten screws to 0.9-1.3 N.m (8-11 lb-in).
2. Pull the radio antenna lead in cable through the door hinge pillar opening. Seat the grommet by pulling the cable through the hole from inside the
vehicle.
3. Route the radio antenna lead in cable behind the A/C evaporator housing and A/C recirculating air duct and retain with pushpins. Connect to rear
of radio chassis.
4. Install the cowl side trim panel.
5. Install radio chassis.
